What the code means
E08: Low flame current
The Trane S9X/S9B integrated furnace control table identifies E08 as low flame current that is still strong enough to allow operation.
Troubleshooting code
Back to all S9X2 96 Two-Stage Gas Furnace error codes
Trane S9X2 96 Two-Stage Gas Furnace E08 troubleshooting
Low flame current. Use this page to document the issue and prepare for service. GreenFlow should handle diagnosis for electrical, refrigerant, lockout, or recurring conditions.
Safe checks before calling
- Confirm the thermostat is on, set correctly, and calling for heating or cooling.
- Check the air filter and visible return-air path for obvious airflow restrictions.
- Look around the outdoor unit for leaves, snow, ice, or other visible obstructions without opening the cabinet.
- Take photos of the thermostat, outdoor unit, nameplate, and any visible flash pattern before scheduling service.
When to stop and call GreenFlow
Call GreenFlow if the code repeats, the system is locked out, heating or cooling is not restored, there is ice buildup, electrical odor, unusual noise, or any issue involving pressure switches, sensors, wiring, refrigerant, reversing-valve operation, or warranty coverage.
Share the visible code, model and serial number if available, photos, current symptoms, and whether the issue affects heating, cooling, or both.
Showing services from our catalog
ResidentialCommercialSupport
AHRI Certificate Matching Support
Match supported indoor and outdoor equipment combinations to AHRI certification records for planning and documentation.
View service details
ResidentialRepair
Air Conditioner Blowing Warm Air
Find the cause of warm air from a central AC system and restore proper cooling where possible.
View service details
ResidentialRepair
Air Conditioner Not Cooling Repair
Diagnose an air conditioner that runs but does not provide expected cooling.
View service details
ResidentialRepair
Air Conditioner Short Cycling Repair
Diagnose frequent AC starts and stops involving airflow, controls, electrical parts, sizing, or refrigerant conditions.
View service details
ResidentialRepair
Air Conditioner Water Leak Repair
Diagnose condensate drainage, pan, coil, and pump conditions that cause water around an AC system.
View service details
ResidentialRepair
Air Conditioner Will Not Turn On
Diagnose an AC system that does not start or respond to the thermostat.
View service detailsE08 questions
What does E08 mean on a Trane S9X2 96 Two-Stage Gas Furnace?
The Trane S9X/S9B integrated furnace control table identifies E08 as low flame current that is still strong enough to allow operation.
What Trane message is associated with E08?
The Trane source used for this page associates E08 with "Low flame current". Match the visible display text, LED pattern, or alert wording to the exact code whenever possible.
What system area does E08 point to?
This code is grouped under flame sensing in the source-backed Trane troubleshooting data.
Which Trane documentation supports this E08 page?
Source-backed Trane FNR-SVX002A-EN integrated furnace control error-code table for S9X2 two-stage furnaces.
Is E08 related to combustion or furnace safety controls?
The Trane source row places this code in a combustion, ignition, limit, flame, or pressure-switch safety context. These codes should be interpreted from the exact equipment board and documented flash pattern.
Does E08 involve a control, board, drive, or module?
The Trane source row points to flame sensing. Record the exact code and visible alert text before any reset so the control history is not lost.
What information should be captured for E08 before clearing alerts?
Capture the exact code, any displayed alert text, the model and serial number, thermostat or control status, operating mode, symptoms, and photos of the display or LED pattern before the alert history is cleared.
Brands We Service
No matching featured brand found.